Padel Craft USA Premium Court Solutions

Common Padel Court Problems and How to Prevent Them

By the Padel Craft USA team · Published Nov 17, 2026 · 5 min read

The short version: padel courts are durable, but trouble starts in predictable places: the turf where players move most, glass corners and fittings, steel where water collects, lighting drivers and seals, and a base that drains poorly. Most problems start small. A simple routine and the right questions when you buy prevent most of them.

A new court looks perfect for a long time, which is exactly why maintenance gets pushed back. The owners who stay out of trouble are not lucky. They know where a court fails first and they check those places on a schedule. This is where to look.

Where problems start first

PartFirst sign of troubleWhat to do
Turf and sandFlattened or worn zones near the baseline and glass corners, uneven sand, uneven bounceBrush weekly, keep the sand level, ask about the turf specification
Glass and fittingsRattling, loose clamps or gaskets, chips at corners or edgesCheck fittings often, replace chipped panels
Steel structureRust at the bottom of posts, at welds and at fixing points, chipped coatingTouch up the finish, inspect after storms
LightingFlicker, dim fixtures, moisture inside a fixtureCheck seals, re-aim fixtures, plan spare parts
Base and drainageStanding water, settling corners, cracks at jointsFix small cracks early, keep drains clear

1. Turf and sand

Where it starts. Traffic is not spread evenly. Players spend most of their time near the baseline and the glass corners, so the turf flattens and wears there first. Sand also drifts into the same zones and leaves other areas thin.

Why it happens. Too little or uneven sand, no brushing routine, and turf built to a low standard. Uneven sand changes the speed and bounce of the ball and wears the fibers faster.

What to do. Brush the turf weekly, spread the sand back evenly and top it up when it runs low or uneven. Watch the high-traffic zones closely. Ask how long the turf is warrantied. Ours has a 5-year warranty, listed on our warranty page.

2. Glass and fittings

Where it starts. Corners, the panels near the entry door, and the back wall where balls hit hardest.

Why it happens. Hot weather makes glass and frames expand and contract. A base that is not flat puts stress on panels. Hardware and gaskets that are poor quality loosen under vibration from constant play.

What to do. Check fittings regularly and tighten what has loosened. Look at corners and edges for chips, because tempered glass cannot be repaired. A chipped panel is replaced. Read more about thickness and certificates in our guide to padel court glass, and ask how long a replacement panel takes.

3. Steel and corrosion

Where it starts. At the bottom of posts where water collects, at weld joints and at fixing points, including the points where a cover attaches.

Why it happens. Salt air and humidity, a coating that does not reach the inside of tubes, and low-quality steel. Coastal courts feel this first.

What to do. Choose hot-dip galvanized steel with a paint finish, touch up chips before rust spreads, and inspect after heavy storms. Coastal sites need checks more often. Our courts use hot-dip galvanized steel with an oven-baked paint finish and a 10-year warranty on the steel structure. See what changes near the water on our Florida page.

4. Lighting

Where it starts. LED drivers, gaskets and lens seals, and mounting brackets.

Why it happens. Fixtures with weak waterproofing, vibration, untidy cabling and sun damage. Lighting is easy to underestimate when you compare quotes.

What to do. Clean lenses, check the seals, and re-aim fixtures after storms or strong wind. Ask which spare parts are available and how fast. See lighting requirements for light levels and glare.

5. Base and drainage

Where it starts. Corners that settle, expansion joints that crack, and places where water pools.

Why it happens. Soft soil, poor compaction, no slope and no drainage plan. Almost every base problem is easier to prevent than to fix.

What to do. Get the base and drainage right before the court arrives, repair small cracks early and keep drains clear. Our guide to planning and designing a padel court starts here.

Smaller problems that annoy players and neighbors

Do owners actually maintain their courts?

Routine care is easy to skip because a court looks fine until it does not. The bill arrives later: turf replaced sooner, glass or lights failing early, rust spreading. Give one person responsibility, put a short checklist on the calendar and keep dated notes and photos of every check. Our maintenance checklist gives you the weekly, monthly and seasonal steps.

Prevent problems when you buy

Many of these problems are decided before the court is built. Ask every supplier:

Our guide on how to choose a supplier has a comparison sheet, and the budget checklist shows the costs around the court.

Climate changes what fails first

Our state pages explain what to ask locally: Texas, Arizona and New York. We support the courts we supply, so contact us with questions about inspections or parts.

Talk to us about your court

Frequently asked questions

What fails first on a padel court?

The turf in high-traffic zones near the baseline and glass corners often shows wear first. Loosening fittings come next, and on coastal courts rust at the bottom of steel posts.

How often should I brush padel court turf?

Weekly, and more often on busy courts, so the sand stays level and the fibers stay upright.

Do padel courts need a lot of maintenance?

Less than many facilities, but not none. Plan weekly brushing, monthly checks of glass, hardware and lights, and an inspection after storms.

How do I stop padel court mesh from rattling?

Check and tighten the clamps and fixings, and look for loose or damaged panels. If it keeps rattling, ask your supplier to inspect the mesh and its fixings.

Keep reading

Questions about your court?

Tell us about your court and location. We reply by email.

By submitting, you agree to our Privacy Policy.